Shoemaker's stand of the type used in Łódź Ghetto

Identifier
irn3437
Language of Description
English
Alt. Identifiers
  • 1990.285.8
Level of Description
Item
Source
EHRI Partner

Extent and Medium

overall: Height: 23.500 inches (59.69 cm) | Width: 9.500 inches (24.13 cm) | Depth: 8.875 inches (22.543 cm)

Archival History

The stand was acquired by the United States Holocaust Memorial Museum in 1990.

Acquisition

United States Holocaust Memorial Museum Collection

Scope and Content

Iron shoemaker’s stand with an interchangeable last, or foot-shaped form, similar to those used by Jewish forced laborers in the Łódź Ghetto in German-occupied Poland from May 1940 to summer 1944. The stands with metal lasts were typically used for shoe repair, while wooden lasts served as a model to which the leather uppers could be attached. Łódź was occupied by Germany a week after the September 1939 invasion of Poland. It was renamed Litzmannstadt, and in February 1940, the Jewish population of about 160,000 people was confined to a small, sealed-off ghetto. All residents had to work, and 85 percent of the ghetto population labored in nearly 100 factories. The major ones produced textiles, including uniforms for the German Army. Occupying authorities seized much of the specialized machinery from the Jewish population, forcing them to use hand techniques for production. Due to severe overcrowding and scarce food, disease and starvation were common. The Judenrat (Jewish Council) administered the ghetto for the Germans, and chairman Mordechai Rumkowski thought hard work and high output would preserve the ghetto. However, in January 1942, mass deportations to Chelmno killing center began; half the residents were murdered by the end of the year. In summer 1944, Łódź, the last ghetto in Poland, was destroyed and the remaining Jews were sent to Chelmno and Auschwitz-Birkenau killing centers.

Conditions Governing Access

No restrictions on access

Conditions Governing Reproduction

No restrictions on use

Physical Characteristics and Technical Requirements

Rusted, cast iron stand and removable last (or shoe form). The base of the stand has three rounded lobes; a tall metal rod, approximately 1.5 inches in diameter, extends upward from the center. The sides of the rod flatten to form a metal sleeve with a triangular cross-section, which has a series of numbers embossed vertically down one side. At the top is the last, which is comprised a triangular-shaped shaft that attaches to the stand with an arm at the top. The arm extends out and resembles an upside-down shoe sole with a curved toe, flat heel, and a rim at the bottom that holds it in place. The back side is flat and rises upwards, then turns sharply and extends at a 45-degree angle. The opposite corner curves upward, creating a ridge on the underside of the last.

Corporate Bodies

Subjects

Genre

This description is derived directly from structured data provided to EHRI by a partner institution. This collection holding institution considers this description as an accurate reflection of the archival holdings to which it refers at the moment of data transfer.